COB LED Test Machine

High-power components, light-engines or LED-arrays can be tested on the AT100. The design incorporates a sphere for absolute optical measurements of all components of the lead frame or product carrier. The design is optimised for full optical isolation, ensuring accurate and repeatable analysis results. The AT100 Test System runs a variable test optical and electrical test programme, including dim test (power-up and evenness) and extensive optical (peak/dominant wavelength, CIE x/y, CRI, Luminous Flux and Efficacy, etc.) and electrical tests. An optional heating element allows temperature dependent tests from 25° to 100°C (77°F to 212°F).

The results are mapped and provided to upstream processes, like our AB 330 singulation and sorting machine or to manufacturing data systems. We can also incorporate camera measurement solutions for relative value analysis. An optional ID reader can determine the lead-frame or unit ID before test. A post-test laser marker would be used to mark test results or product IDs onto every single product of the carrier or lead frame. We can also add our singulation module pre-test to test singulated units.

The system processes ca. 100 substrates per hour, depending on number of LEDs on the substrate and the test time.

Share this Product

Subscribe to our Newsletter
  • Micro Modular System Sdn. Bhd.
  • 84A Lintang Bayan Lepas 9
  • Bayan Lepas Industrial Park Phase 4
  • 11900 Penang, Malaysia
  • Tel:+604 - 6460 888
  • Fax:+604 - 6467 516
  • This email address is being protected from spambots. You need JavaScript enabled to view it.
© 2020 Micro Modular System Sdn. Bhd. All Rights Reserved | Beyond Automation